Interested to Buy Any Domain ? << Click Here >> for more details...
how to find out spacing inbetween bars instead of 8dia
100c/c to 10dia bars
- 5 Answers
- 8836 Views
- I also Faced
- E-Mail Answers
Answer Posted / san
125mm
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
What is the cost of shuttering per Sqm.? How it is calculate by thumb rule...?
What are the reasons for geotechnical site investigations in uganda?
kindly mail me by attaching files , formats for quality checks of common building materials like cement , concrete , bricks , sand and aggregates plz send my email id- VMANDAL91@gmail.com
the water is flowing through a velocity of 1.5m/s in a pipe of length 2500m and dia 500mm. at the end of pipe a valve is provided. find rise in pressure 1. if the valve is closed in 5 seconds. 2. if the valve is closed instantaneously. take value of c = 1460m/s, pipe to be rigid and bulk modulus of water - 19.692x10' n/sqcm
Can you pl explain the procedure steps of singly and doubly reinforced beams in limit state method
how to calculate the mortar for 10'*10' size room for both plastering and for masonry work?
how to calculate valuation for the old building?
plz drive the formula d2/162.162 for the calculation of weight of steel bars????
Specific gravity of cement?
How to calculate volume of concrete & steel on tank foundation & ring wall ?
What is the difference between Grade I, II and III of GSB?
i have to give lap joint fo 1Mtr steel of dia12mm,whenever i did mistake i cut less 5cm plz tell me how much i will give lap joint so that length comes 1Mtr
what is the code provision for acceptance of fineness modulus range for fine aggregates in design mix
how to calclate the SHUTTERING TAKEN CONCRETE LOAD? WHAT IS THE LOAD BEARING CAPACITY IN STEEL SHUTTERING PLATE? WHAT IS THE CONCRETE LOAD IN (MASS) IN THE SHUTTERING PLATE. PLATE SIZE IS 120CM* 90CM CONCRETE WALL LENGTH IS 10M ,WIDE IS 60CM, HEIGHT IS 1.2M PLS TO SENT THE CALCULATION.
What is the difference in painting using Roller and Brush? What is the paint consumption difference? As per IS one coat of painting is painting from left to right and top to bottom whether this can be done using roller ( Roller Stick height and feasibility) ?
