Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / omak
In automatic controller there are two modes available to control the process. One is called Automatic mode, it will control the process automatically by comparing the feedback input with the set point. The another method called Manual mode, in this mode the operater check the measured input from the field and give the command manually for the final control element.
| Is This Answer Correct ? | 7 Yes | 0 No |
Post New Answer View All Answers
Good evening all I need a small favour regarding reliance paper i wanna probable sample papers(e&i) of reliance. if any of u have any idea about dis then plz mail me back.i belongs to electronics and instrumentation engg.so i need e&i papers. thanking u....
In turbine what does term CDP, NH, HSSOC means.
What is voltage regulator?
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
Draw a simple circuit for a well head control panel used to protect the well against fire, leak, blockage, ESD, & controls the operation of one downhole & one surface safety valve. Explain the operation and controls
please send data bank of quetions answers on analytical instrumentation.
how will you check torque value during Factory acceptance Test for control valve/ESD ON/OFF VALE how will you confirm this torque value is being correct, Which document will you be refer.
what is your eligibility criteria for freashers?
what deference between panel earth and systemearth
Explain pH, Conductivity.
what is metal of piston ring
need instrumentation job completed 1 year trainee ship in mnc pesticide company. now in search of job
How to Calibrate Flammable gas detector in field
How to calibrate Field bus transmitter? procedure ?
What is offset in a control system.
