Interested to Buy Any Domain ? << Click Here >> for more details...
hi everybody. right now i am working with thermal power
plant. our company plant is tripped because of program
corrupt. i would like to know is it possible when the plant
is running. we are using FREELANCE ABB800F CONTROLLER.
- 2 Answers
- 4373 Views
- I also Faced
- E-Mail Answers
Answer Posted / jayesh patel
hi i have exprience in petrochemical and power plants
severly in dcs system there is no chance to have failure of
program because in dcs system ther will be two system one
will be master and another will be slave the running system
will be observed by master processor and if master
processor will currupt it will shows alarm to the system
and in same time slave system come in action due to failure
of master processor and in that curcumstrances we have to
check the master processor why it was fail then if the
problem is solve then can take master processor online
manualy and check its output as same as slave processer and
if found ok then we can take in auto mode
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
How can we use feedback signal frm rtd for monitoring and in dcs for controlling ,then which type of rtd is sutaible 2 , 3,4wire and why ?
what is performance test.need defination
Draw a wheatstone bridge circuit showing supply, meter and 3 wire RTD connection
A DP transmitter is used to measure the level of an open tank. The drain line of the tank is connected to a control valve, and is configured as, if the level of the tank is 90% the valve should get open 10%. And if the tank level is 10%, the valve should get open 90%. Draw wiring diagram and explain how to configure DP transmitter and control valve using HART communicator. If the span error at output is 1%, what will be the %opening of the control valve at 60% level of the tank?
what is the difference between -24 : +24 & 0:24 and where it use?
hi my name is rakesh patel i just complited my be in instrumentation & control now i am going to working as a validation engineer in a poject department so what is a scope in a future as a validation engginer ? what line is good for me can any bady give me complete solution please? your regard rakesh patel
what is the difference between attemperator and desuperheater ?
what is difference between fork type and capacitance type level switch. where it is using
Displace type LT to be calibrated in workshop, wt. 40, dia- 60 mm, density- 0.8kg/cm3.
What is the PLC configuration in Cement industry?
What is the meaning of wet leg
Operational amplifiers
what is the importance of CV in the control valves? how it is calculated?
how to calculate range of level transmitter?
what is the electrical operation procedure for switching on 27.6MVA electric furnace.
