Interested to Buy Any Domain ? << Click Here >> for more details...
What is RTCC panel and why it is required
- 31 Answers
- 133975 Views
- RTCC, Tivoli Grand, I also Faced
- E-Mail Answers
Answer Posted / kiran.electra
RTCC STANDS FOR REMOTE TAP CHANGING CONTROILLER IT IS USED
TO BALANCED OUTPUT VOLTAGE WHICH THE TRANSFORMER IS RATED
FOR AND IT CAN BE CONTROLLED FROM REMOTE AREA AND THE TAPS
ARE PROVIDED ON H.T. SIDE BECAUSE THE HIGHER VOLTAGE
INDICATES LOWER CURRENT AND THERE WILL BE LESS SPARKING
WHEN THE TAPS ARE CHANGING AND INSULATION REQUIREMENT
CONSIDERABLY CHANGES
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
what is distribution board?
If 22 KV HT line, Current transformer is 25/5 then how to calculate multiplying factor.
dear sir, i completed diploma in electrical in 2005, how i can get electrical supervisor liance in mumbai
what happen if the load connected to the induction motor is taken away? the same question for synchoronous generator in synch i think that the the exitation voltage will appear on the terminal only if so plz answer me
Damping resistor provided in open delta (tartiary) winding of a measuring PT at the incoming of a MV inverter drive panel is getting heated up. Can any body explain the reasons and suggest the remedy?
what is the reactive power what is the use of it in system
what is the difference between the characteristics of two different phase bushing of any transformer
what is the maximum temperature rating of a thhn insulated conductor?
What is safety of Ht panel
What is an Air COmpressor
Why have to use copper cable for local isolator to motor ?
Why we cant store an ac power. If we coo store in which device we can?
I have 440v power coming to facility,( not being used ) can I buy large generator, (gas) to sell power back to electrical co.
1)how to reduce the value of tan delta of trasformer and CB,bushing,CT&PT,CVT ? 2)how to reduce the resistance of CB contact and its operating time? 3)plz.....send me the project report on conditioning and monitoring of substation equipment on my email id (gusaiyogendra03@gmail.com)
What is meant by full pitched winding?
