Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / manish kumar janagal
also by using a 1 phase alternator connected to 1-phase
supply in such a way that it's frequency is just less than
the supply frequency
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
What is the difference between a 3 winding and 2 winding Potential Transformer
how to calculation increase capacitor,increase power factor for three phase.
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
how to calculate compresor capacity?
Explain the method to keep noises low in a control system?
how to select battery for 15 KVA UPS with formula
I am inpecting a 10kVA UPS what tests should i do and should i observe?
how 650 volts creates? where is use?
what is accuracy ? in any meters , coils accuracy . how can u defined that ?
What range of speed can you get with the armature control method of speed control of d.c. Shunt motor?
How to calculate wire length,size & current? ( related to control panel)
What is transformation ratio what it describes?
While converting delta into star or star into delta ,the three values of resistances remains unchanged .Find out the value?Let In star R1=x;r2=x;R3=x On converting into delta,R12=x;R23=x;R31=x Find the value of x
What is the formula for calculating impedance of transformers connected parallel at fault level 50KA?
What is bridge rectifier and explain with details
