What is the current flow in 230v ac supply ? What is the
current flow in 415v Ac supply ?
- 1 Answers
- 5626 Views
- I also Faced
- E-Mail Answers
Answer Posted / sanjay kumar
The quantity of current depends upon the load. Larger the
load, lesser will be current drawn on constant supply.
REMEMBER the Simplest formula of Electrical Engineering i.e.
OHM's LAW V=I*R
in given question V(=320 or 415V) is fixed. Now larger the
load small will be current and Vice Versa Lesser the load
Larger will be current drawn.
The highest current (in Amperes) can be equal to System
Voltage (in Volts) when there is no load (short circuit to
be precise) Hence current is too high and spark is produced.
| Is This Answer Correct ? | 8 Yes | 2 No |
Post New Answer View All Answers
how we can calculate power factor in single phase & three phase ?thank u
DRAW ACIRCUIT DIAGRAM OF 100 KVA 415V/55-0-55V DELTA TO STAR TRANSFORMER
What are the site acceptance tests for power cables, DG Sets, LT panels & 30kVA UPS ?
hwat type of motor is used in thermal gas turbine hydro nuclear power plants and why
upto how much low RPM we will run the commercial motor which is run through VFD without any problem occurs in motor.Motor rating Duty is S1 & RPM is 1400.
sir vizag steel ka junior trainee ka paper kitne number ka ayega
3- What is the target from Zero Impedance, Single Phase Imp., S/C Imp. and magnetic balance tests?
how to calculate cooling requirement of datacentre from electrical load?
we have 2.2kw,Y,3000rpm motor but 6leads found in TB what happen if we connect in delta?
Draw a circuit diagram in which if button is open we can use socket and bulb as a series test circit and if button is close than simple we can use socket as any load purpose.
how a resistor resists to flow the current?how an inductor oppses the sudden change in current?how a capacitor opposes a DC voltage.
What is deference between MCB & MCCB & ISOLATOR
Which motor will you choose which can operate in both lagging as well as leading power factors?
1.how many types of relays? 2.difference between ATS& STS?
I need the recommended size for a 3 phase transformer at 13.8 KV Primary and connected loads of 3000 kVA at 4200 volts and 2375 kVA @ 480 volts AC.
