Interested to Buy Any Domain ? << Click Here >> for more details...
generally transmitter power supply having some range(12v to 35v) but the out put(4-20 mA) must same for given input.If we vary the power supply voltage then output mA also to be change according to V=IR. Is there any voltage regulator in the transmitter ?
- 2 Answers
- 5257 Views
- I also Faced
- E-Mail Answers
Answer Posted / manohar m chotrani
In an electronic transmitter power supply varies with the
load attached.Normal power supply is 24V DC for a
transmitter. of this 12 volts are required to run the
transmitter without any load.This will give 4-20 mA as
output as we go on increasing the load we have to increase
the supply voltage to get a 4-20 mA current. Every load of
50 ohms require 1 volt increase in the supply voltage but
upto a certain limit like ABB made transmitter can take load
upto 2020 ohms with the 55 volts as supply.Beyond 55 we can
not increase the supply because operating voltage is 12-55
volts. If we increase the load beyond 2020 ohms with 55
volts current output will be affected.There is no voltage
regulator in the transmitter
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
I WANT SECURITY PAPER MILL, HOSHANGABAD TEST PAPER.KINDLY SEND TO MY MAIL ID
the whole paper was based on Transducers..questions like define repeatability, error,accuracy,precision..den there were many q. on the conversion of Pa to mmHg and other units.. also..der wer few Q. on some level sensors(with diagram)
how to calculate orifice sizing? and tell me if pipe size bet 50mm t0 200mm then we can use pipe flange??? and above 250mm pipe size should i use D & D/2 Flange? is it right or wrong?
what is a half wave, full wave, and bridge rectifer.
what is the calibration procedure for transweigh make weigh feeder?
What is 1:1 redundancy ?
model question paper of instrumentation for Jindal GET 2010.plz reply sudhanshukumar08@yahoo.com
Why do you want to work here
Difference between 2-Valve Manifolds, 3-Valve Manifolds and 5-Valve Manifolds 3 with diagram
Any body have know try work calculation ???
How servomotor controls throttle valve of TURBINE?
How to calibrate RC Feeder system in thermal power station?,If any instrument available to calibrate it,ple inform me. make:stock,
we have a s-5 simense plc having op7 .recently on op7 showing error 1.plc not present 2. DB error frequently. can u have any solution . please send me.
1. what is modbus cable? 2. what kind of communication we are using for the interface of DCS, ESD and Third party cabinets? 3. What is serial communication and peer to peer communication?
what is the different between deflection type measurement and null type measurement in RTD?
