Which IS Code describe the industrial flooring?
- 4 Answers
- 5942 Views
- L&T, I also Faced
- E-Mail Answers
Answer Posted / vinay
The industrial buildings are usually one-story structures
but some industrial building may consist of two or more
storey. Reinforced concrete or steel-concrete composites
slabs are used as a floor system. The rolled steel joists
or trusses or plate girders support these slabs. The design
of reinforced concrete slabs shall be done as per IS 456-
2000.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
WHERE CAN I GET THE PREVIOUS QUESTION PAPERS OF APGENCO FOR THE THE POST OF Tr.ASSISTANT ENGINEER(CIVIL)
what are the code used for residental building?
Explain how you can turn off the display for dimension in CAD?
How to calculate the weight of sand am 20mm course aggregate in 1 c.m M25 concrete Which use 400 kg of cement ?
how to reduce size of column 450 x 750 to 230 x.... if it is cut in area of bathroom? means it appears in bathroon any shifting or any other option....building is g + 10 and the bathroom is at first floor...
What are the advantages of cad software?
why steel tanks are provided (a) for water pressure (b) for wind pressure (c) for earthquake pressure
1) write Short notes about Shellow & Deep well? 2) What is the full form of SPT & SMB? write short notes. 3) write short notes about efficiency of Riveted joint.
What in your opinion makes you the most suitably qualified candidate for this post of civil engineering technician?
What is the cemnent ratio
Method of findingthe dry ingredient quantity of 1 m3 concrete. what is the difference between static and dynamic induced emf? Testing charges bill given for Rs. 32,000/- but not added service tax in this bill. So, How much TDS will be deduct
what is differences between ferrock and concrete ?
is there any codal provision for soil cousion over the Hume pipe of Dia 1.2 m.
How will be cutting in timber plate size 600*400 column size
Design a built-up column carrying an axial load of 1200 KN. Its length is 8m and it is effectively held in position at both ends and restrained against rotation at one end. Assume yield stress of 250 mpa
