what is coriolis principle for mass flowmeter?
- 5 Answers
- 12734 Views
- ABB, I also Faced
- E-Mail Answers
Answer Posted / pravesh ahlawat
This meter uses the Coriolis effect to measure the amount of mass moving through the element. The substance to be measured runs through a U-shaped tube that is caused to vibrate in a perpendicular direction to the flow. Fluid forces running through the tube interact with the vibration, causing it to twist. The greater the angle of the twist, the greater the flow
| Is This Answer Correct ? | 2 Yes | 2 No |
Post New Answer View All Answers
NPN transistor, SCR, Zener diode, LED, Varactor diode, Vortex meter, RTD, Resistor, Crystal
please send me the inteview questions in IOCL
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
what is the procedure for auto tune in masoneialn 12300 series displacer type transmitter?
tell me the field & lab calibration procedure step by step with diagram of pressure gauge, pressure switch, pressure transmitter, temperature switch, level switch, flow switch, flow transmitter, temperature transmitter, temperature indicator, flow indicator, level indicator, control valve, thermocouple, pressure indicator (digital & analogue),
Why all the drains(Gland sealing,ESV,Casing inlet etc) are directly connected to the flash tank instead of hotwell of the condensor in the power plant? My Email Id:naba02222@gmail.com
what is RTV function in in process control?
typical loop drawing of a simple feedback control comprising of one transmitter and one control
how many type of plug are used in pneumatic control valve,name them.
what are the definitions of input, output, command & signal according to instruments controlled by PLC using DCS System?
what is the current pay package for an instrumentation engineer having 2 years of experience in cryogenic technology???????
Which language of programing is popular? how can i learn it ?
what is scale factor of proximitor & unit of the vibration.
in valve is constructed as per SME B 16.34, then which standard is used for fire testing of valve?.
How to calibrate Magnetic flow Transmitter in Field
