Interested to Buy Any Domain ? << Click Here >> for more details...
HOW MANY MAXIMUM BASE REGISTERS WE CAN HAVE IN A PROGRAM
AND ALSO HOW MANY MAXIMUM BASE REGISTERS WE CAN HAVE IN A
SINGLE PROGRAM.
- 5 Answers
- 13233 Views
- IBM, TCS, I also Faced
- E-Mail Answers
Answer Posted / rdm
Any Register between R2 to R12 can ONLY be used as Base
Registers; Other Registers are reserved by the System.
| Is This Answer Correct ? | 6 Yes | 5 No |
Post New Answer View All Answers
Explain how to produce soc7 abend?
What is maximum displacement?
What will happen if we drop the base register in the program which contains only one basereg?
Ap wkur,=p5 where wkur is a label?
What is maximum displacement and how to cross this limit?
What is icm instruction?
What is need of start 0?
Explain the difference between various read and find statement and which one should be used when for better adabas performance?
How are data passed from jcl parm to assembler program?
In the house keeping section of an MVS assembly language program, like the one below STM R14,R12,12(R13) BASR R12,R0 USING *,R12,R11 LA R11,2048 LA R11,2048(R11,R12) .... .... 1. What if BASR R12,R0 IS NOT PRECEDE USING *,R12,R11? 2. USING (base address), REGISTER does USING directive says assembler to treat particular Register as a base register with the mentioned base address..in the above case * i.e current location counter..well if that is the case why we need BASR R12,R0 ? 3. What if I write like STM R14,R12,12(R13) BASR R12,R0 LA R11,2048 LA R11,2048(R11,R12) USING *,R12,R11 there is no address resolution being calculated in both LA statements so is it a right way to set Base register?..will there be any issues with Domain regarding R11 and R12?
Explain the difference between various read and find statement?
how do you round the addition or subtraction of two numbers in assembler? what does the following code do? change process tool(code changes from dev to prd) the changes made to your code should be effected in live. How the process takes place. That is how can you move the code changes from development to production?
how to pass the parameters from jcl to assembler pgm?
Explain about maximum displacement?
what is need of start 0? In steed of
