Interested to Buy Any Domain ? << Click Here >> for more details...
what is the diffrence between mmwc and kg/cm2 for pressure
measurment when we are using mmwc and when kg/cm2 and why?????
?? what is the reason
- 19 Answers
- 204605 Views
- Ecoboard, Jindal, Sepco, I also Faced
- E-Mail Answers
Answer Posted / prashant meena
Mostly both are units of pressure. when we measure the very
low pressure than it is expressed in mmwc else higher
pressures are measured in kg/cm2. low pressure can also be
used for but the error in values will be more.
Basically 10000 mmwc is 1 kg/cm2 a.In thermal power plant mmwc is most useful in boiler side.
| Is This Answer Correct ? | 27 Yes | 10 No |
Post New Answer View All Answers
If P will increase then what will happen with PID?
How servomotor controls throttle valve of TURBINE?
Describe how to use megger to measure the earth resistance and insulation resistance
How hart protocol can be connected with control valves?
If relative y axis vibration sensor is by passed, and relative x axis and absolute sensor is left working. how much monitoring i would have risked?
Any body have know try work calculation ???
What are the different types of thermistors used in industries? How to the operation of typical thermistor?
What is force balance principle?
How ejector(or)evactor air pump is working in thermal power plant?
How to Calibrate Coriolis Flow transmitter in field
what is the input to be given in digital flow meter during the the calibration time?
i want formula for flow control.am doing project in flow control using orifice . i know value of the flow level(Q) . upstream(p1) pressure, orifice diameter(Do) , pipe diameter(Di) and oil viscosity(Vi) how can i calculate downstream pressure
draw the block diagram of a level transmitter ?
what is the responsibility of an instrument commissioning supervisor
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
