Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / nikunj
Master PLC will control whole the system and send or receive
the information & command from the connected slave id's.
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
What is Positive Calibration and Negative Calibration?
what is the responsibility of an instrument commissioning supervisor
i have used level transmitter in starch cooking preparation tank. tank total height 2mtr.sometime LT display shows some error value when tank is fully empty and diaphragm side i already checked okay no problem in diaphragm area. field cable checked 24volt and mA shows correct value while tank empty mA is 4mA. 4mA i needed that 0% but display showing 10% or 15% percentage values are varying continously please give any good solution for me.....
How can you add value to this Industry if offered the job?
What is 3 selection available when configure the burnout protection for controller
the pump holds on run indication into the dcs and filed local control panel remote push button condition operaton wrong like when the push button pushing conditions the pump is off and the push button release condition the pump is on totally opposite condition . And control room inside give the stop command into dcs just 1secon relay engage and again normal condition. How can I slove
how can use ram
How to decrease opening & closing time of on/off valve?
Give Detail information about plc,dcs,and scada system?
how to calibrate load cell
Why is it necessary to use compensation leg to measure the liquid level in a closed or pressurized tank?
what is sliding spool valves?
Explain pH, Conductivity.
Can any one send me IOCL instrumentation question papers.. i dont know the pattern of the questions and what to prepare can any one help me on this .. my email id is anwarnishil@gmail.com
Reason for capillary type dp level transmitter fluctuation
