Answer Posted / ashu
At Constant Temperature, Under Normal conditions Voltage across two ends of a conducting material is directly proportional to current passing through it.........
i
0========>========0
<-------V--------->
v=i*R
| Is This Answer Correct ? | 3 Yes | 5 No |
Post New Answer View All Answers
What is the difference between rulling span and wind span of of an Over Head Transmission Line?
How to measure power in 2 or 4 or n phase circuit? Please give me a formula.
Why different Pressure switch used in marine boiler water circulation system
What is the suitable transmission voltage?
why US countries maintains 110v and 60HZ
What is meant by stator? What is meant by rotor?
What are the types of class b amplifier?
Explain the operation of grid connected central solar inverter ?
What is turn ratio of a transformer?
i need about 10 years of GATE solved papers in pdf format and even mock tests toooo
What is the formula to find out two phase active & reactive power
how point on wave controller works.
what is the difference between STAR and DELTA connection and application wise how it can be utilizedd
1)what is the function of a frequency inverter? 2)If a few frequency inverter are connected onto a device network,what are the two setting that will ensure the frequency inverter work properly on the network. 3)whats is the name of the input sensor for weigher? 4)How to confirm that the load cellis faulty? 5)Describe briefly the steps to validate that the weigher is working properly? 6)Describe the procedure to validate the flowmeter accuracy? 7)Describe briefly the steps to validate that the tempreture sensor/transformer is working properly. 8)what is the adjustment that need to be done when you are calibrating the temperature transmitter ? 9)what are the safety measures to be taken before disconnecting motor for rewinding. 10)whats is the synchronous speed in rpm of typical 4pole 50hz motor? 11)whats is the formula for kw, ohm's law 12)if a 3phase motor is rated 3kw,415vac,what is it's rated ampere?
How Load Factor, Demand Factor, Diversity Factor etc best applied in designing an electrical circuit? Is it allowed to consider these factors in each and every panel in an electrical distribution system? Can any body suggest a good book for reference?
