Answer Posted / anil

Multi-strand conductor is stranded conductor. i.e solid area
is divided into no. of small area's( 1 sqmm wire is having
14 strands of 0.3 mm dia. which gives equivalent area for 1
sqmm solid conductor). By stranding the conductor, total
circumference will increase as compare to single solid
strand. further, 0.45mm should be dia of single strand and
370 would be the no's of strand in the cable.

why does connected a indutor with mnsformeretering core of current transformer ?

2139

---

If a shunt Dynamo has induced emf 100V and 0.4 ohm resistance and battery of accumulator of open circuit emf 110V and 0.5 Ohm resistance are in parallel what is common terminal potential difference?

5245

---

what is the difference between gas group b and gas group c electrical equipment construction wise?

1874

---

explain transformer ct connection?

2063

---

what is feeder bay?

1597

---

What is the effect on power factor, shown by a trivector meter; incase of reverse phase sequence. If the power factor of a system is lag what meter will show in case of reverse phase sequence connected to the meter. and What in case of lead.

2320

---

why and how current drawn by battery charger depends upon the altitude where it is located?

2041

---

How do apply electrical 'c'license......pls advice

1713

---

In case of salient pole alternator when number of poles are 4 or more than 4 it helps the flux wave to be sinusoid as air gap length is increased from center to tip , but if the number of poles are 2 how does the flux wave is sinusoidal?

1979

---

what is auto re-closer?

2640

---

Keywords: Die, Card, Coin, B/N 2 To 12

1284

---

WHAT IS THE PARTIAL DISCHARGE TEST?

2120

---

What will be the diameter of pipe between conservation tank and transformer

1936

---

what is the difference between general inverter and solor inverter clerly explain plz

2099

---

What is ST and specify its range of voltage.

1976

---