Interested to Buy Any Domain ? << Click Here >> for more details...
what is the diffrence between mmwc and kg/cm2 for pressure
measurment when we are using mmwc and when kg/cm2 and why?????
?? what is the reason
- 19 Answers
- 204580 Views
- Ecoboard, Jindal, Sepco, I also Faced
- E-Mail Answers
Answer Posted / tapan das
Mostly both are units of pressure. when we measure the very
low pressure than it is expressed in mmwc else higher
pressures are measured in kg/cm2. low pressure can also be
used for but the error in values will be more.
Basically 10000 mmwc is 1 kg/cm2 a.
| Is This Answer Correct ? | 33 Yes | 7 No |
Post New Answer View All Answers
how can i calibrate the temperatuture gauge used by temperature bath(dry block) i mean step by step procedure?
why we are not using the turbine flow meter in the steam service?
How to decrease opening & closing time of on/off valve?
this site is owned by an nonsense
when the instrument tapping on pipe line is located below and transmitter is located above the tapping point for liquid service transmitter, what should we do, is there any additional drain valve is required??
What care will you take in the installation of control valves,SCADA,DCS and FOC in Oil and Gas Project?
In control valve proximity inductive sensor is taken as digital feedback for full open and full close.Normally its volts 24v when the sensor acts the feed back voltage 14v so that our relay not indicating in plc panel . kindly give the solution.
What pressure results for a flow transmitter of range 0- 180t/h in the dcs and 0-301mbar in the field using square root extraction. Kindly also suggest formulae for the percentages 0,25,50,75,100?
what do u mean by compensation n pid tunning?in pid tunning what you tunned?is it possible 2 tune p i d
god evening sir i am studying m.sc(tech)electronics &instrumention.am i elegible to all industies
Working principle of magnetic flow meter ......and calibration procedure of e+h magnetic flowmeter...
what is isloted barrier how it works and what are the main purpose.how it make safe area.
hi,i am doing 3 year in electronic and instrumentation engineering. what type of aptitude questions will be asked in a core industries and how can i improve my skills in instrumentation?
How do you identify an orifice in the pipeline?
What are the types of valves?
