Answer Posted / bunny
A closed control loop in a very basic manner consists of
sensor, transmitter, controller,signal converters and final
control elements.Actually in a practical loop there will be
many other instruments apart from this to support the
working of above mentioned instruments.
| Is This Answer Correct ? | 21 Yes | 2 No |
Post New Answer View All Answers
how many pulses are required by a ac induction servo motor of 4 poles with 50 Hz frequency to rotate by 1 degree?
What is force balance principle?
what about your moleg in pogrees with company
How would you choose differential range?
you are on site,the plant trips,you are approached by operations,what do you do?
Explain bernoulli’s theorem. State its application.
What happen if we install my pressure transmitter below the elevation of pipe in natural gas service?
I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?
how can leve transmetter calibate in feild .and also put cv and flow plz .....
I faced several time siemens ps2 positioner automatically getting Chang in it's set point direction after auto calibration So is there any causes biside this or any permissives ?
dear friends, i have seen flow as the selection critriea in presure guage (bourdon tube) and i would like to know what is the relation between flow and performance of pressure guage other parameters i found in the data sheet are pressure max. 1ksc temperature max. - 50 deg c line size - 80NB operating range - 1ksc pr. guage range - 0-2 ksc thank u,
we have level transmitter for h2s04 storage tank capacity 10k ,always there are failure of transmitter due to failure of magnetic floats ,please come up with solutions at the earliest.
In turbine what does term CDP, NH, HSSOC means.
POSSITIVE PULSE IS APPLIED TO AN INVERTER INPUT.THE TIME FROM THE LEADING EDGE OF THE INPUT TO THE LEADING EDGE OF THE OUTPUT IS 10 ns. THE TIME FROM THE TRAILING EDGE OF THE INPUT TO THE TRYLING EDGE OF THE OUTPUT IS 8 ns. WHAT ARE THE VALUES OF tPLH and tPHL?
Sir, I am working as a Instrument Engineer in Grasim Industries. Can any body provide question answer for interview purpose
