Interested to Buy Any Domain ? << Click Here >> for more details...
what are the various types of earthing? plz give brief
detail of all. also post pictures if u have.
- 22 Answers
- 46985 Views
- Aster Teleservices, Era Infra Engineering, Micron Electricals, I also Faced
- E-Mail Answers
Answer Posted / pak-engineer
hi hope all of you fine,
Friend,
as you know there are two type of earthing but tachnic are different, or you can say it Technic or various types of earthing.
1-System earthing
i-IT
ii-TNS
iii-TNC
iv-TNCS,,,,,etc
2- Equipment Earthing,
i-Bounding.\
you can get more detail if you required let me know, i will send you by mail attachment
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
What is voltage ratio of a transformer?
What is the Minimum winding resistance of motors ( small & big)? referance range
Whether it is possible to measure energy at the input of rectifier transformer (12 pulse with very high odd harmonics)
how to calculate current carring capacity of cable and cable selection? 1) copper flexible cable 2) copper armoured cable 3) Aluminium cable
What is primary and backup protection?
how to increase senstivity of ct
SUTIABLE FOR ohm's law super conductor
When we use 3 terminal resistor?
WHAT ARE THE EFFECTS OF SERIES RESONANCE AND PARALLEL RESONANCE ON THE CIRCUITS PARAMETERS?
If only R Phase is connected in 2 pole elcb, n is not connected than it will work or not in ground fault.
As per standard, transformer body earthing and other Equipment earthing (Equipment earthing) did not connect. but in LT side termination we are doing metal glanding in both side Transformer to PCC Panel through armoured cable, now X'mer body earthing and PCC Pane earthing (Equipment earthing) both are connect.is this safe for X'mer or other equipment?
What must be the distance between the Earth pit which are grounded from two different sources. Example: Distance between the earth pit for LV Panel-1 & 2
Write the current equation in series RLC circuits.
what will happen if frequency is below 50 hz?
why in the three pin plug all 3 pins are cutted ?
