Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / ramesh
For load calculation we should to assuming Current power factor
If PF lies 0.8 load value= 800*0.8=640watt
If PF lies 0.6load value =800*0.6=480Watt
| Is This Answer Correct ? | 9 Yes | 0 No |
Post New Answer View All Answers
how to design the heater in temperature control unit to heat 50KL of water?
what is the step by step formula for calculating bus bar phase and neutral size of a panel board.suppose the incomer of panel board is 100A..???step by step answer please
is this the formula of building wiring to get the main breaker.Watts/volts*.8%+higher motor*(25%)=ampere. yes or no or send the correct formula for building wiring.
How to calculate cable size by using load.?? Any formula...
What is difference between start imitation and start interlock for 3 phase motor protection ?
Why can't we take NO LOAD TRIAL of motors having V1 mounting??
Why to keep capacitor bank off while generator running.
what is meant by tranformer impedance?
what is the difference between an alternator and a synchronous motor
what are different types of electrical windings? i know the distributed winding ,concentrated winding etc but i want some detailed information, in what condition we will use distributed,concentrated windings what are the difference between them which is best, how induced emf changes by using different types of windings 20 hours ago - 1 week left to answer
How to checked frequency drive output voltages?
What is the permissable nutral current of three phase system as per IS standards?
why do we have spikes enough to burn electronic boards, when generators are not grounded
Why insulation level follows this order? transformer < bus bar < circuit breaker & Isolator < transmission line.
Can we use a absolute encoder to show rpm of a motor ? what about the condition when power is off ? what is difference if a incremental one is used ?abanirout@gmail.com
