Interested to Buy Any Domain ? << Click Here >> for more details...
What are the possible causes if load is not same on all the
three phases
- 4 Answers
- 6205 Views
- I also Faced
- E-Mail Answers
Answer Posted / karthick
to be check the phase angle in three phase line,
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
why ct ,cvt should be stored in a vertical position?
why we testing the core balance of the transformer before comissioning?
sourse is 66 KV / 350 MVA, transfarmer is 1000 KVA 6.6 / 0.415 kv, iF fault is 28.75 MVA on 0.415 KV Bus then calculat the Transfarmer Impidance
Explain the working of any one cutting machine
in a silicon diode we can measure .7v in a voltmeter.but why we can't use this voltage for using?
What is the difference between Droop vs Isoch Control?
I have made a 3 phase thyristor full bridge rectifier. But at the moment it is working only for the half bridge operation. Both the half bridges are on operation separately but when i put it into full bridge operation the oscilloscope output is zero. I rechecked that the pulses are correct for each thyristor. what could be the possible reason for this?
What are the types of feedback oscillators?
What are the uses of stepper motor?
Why the efficiency of a three-phase induction is the motor is less than that of a three-phase transformer?
Why we use 4-20 mA Analog signal for the PLC input? Why not 0-20 mA? Why not 5-25 mA?
Could Please Explain briefly. Why used stabilizing resistance series with High impedance bus differential protection relay.
why burdens of VTs is more than CTs?
how many joint can done in HT line and what is life of the joint
in a solar power plant,we are going to step up the voltage 350V to 33kv, and to 132kv GSS. i want to ask that if it is possible that 315v/33kv is not possible because we also use 315v/11kv. or it should be 415v/33kv? is it effects generation or losses? the second question is-generation is depends on LV winding? or LV winding design for generation voltage?
