Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / aftab ahmed mazari
These are flow paterns.
a. Equal percntage
b. Linear
c. Quick opening
The plug and cage is made in such a way that you can get
flow any one of above construction.
Suppose, Valve cage, plugs are Equal percentage, then at
opening of valve of 30 percent, you may get flow of only 6
to 8%
If linear, then flow also 30%,
If quick opening, then flow almost double, about 60%,
It all depends upon process requirements.
Suppose for vent valve, usually quick opening type valves
are used
aftabmazari@yahoo.com
| Is This Answer Correct ? | 6 Yes | 0 No |
Post New Answer View All Answers
Which products are available in the Mass Systemswitch and System Manager AC range?
selection of the zener barrier for the hazardeous area zone 0
i have been asked by QAFCO to appear for interview for thy post of Instrument Designer(INTOOLS)..i m engineering graduate with 5 years exp. in design engineering.Will this job profile suit me??i need all ur help n suggestions for thy same?
Q1]IF THE RANGE FOR FLOW IS -35 TO 125 WHAT WILL BE THE SPAN FOR ABSOLUTE AND FOR NORMAL? Q2]HOW TO CALIBRATE CAPILLARY TYPE LT? Q3]HOW MANY ERROR CALCULATIONS ARE THERE USED IN PROCESS INDUSTRIES? Q4]HOW TO CALIBRATE TEMPERATURE TRANSMITTER? Q5] HOW TO CALIBRATE LEVEL TROLL AND HOW TO CONNECT? Q6]PLEASE TELL ME THE BASIC FOR INSTRUMENTATION WHICH IS APPLIED FOR CALIBRATION AND FOR ALL? PLEASE MAIL THE ANSWER TO honest_yes@yahoo.in
Why rdt and thermocouple both give different output .and one things more, how to generate ohm or mili volt plz mail me merajalam143545@yahoo.com
In which principles tx ,pressure gauge,Temp gauge,control valve works?
Can anybody tell me how to select the size of earthing cable for DCS & PLC system.Please tell me any relevant answer here or mail it to me.
what is cold loop? difference between hot and cold loop?
Can anyone send most commonly asked interview question in Oil & Gas industry
What is three element in drum level?
give eg of how I/P is used in control loops
Please any one can provide latest aptitude test,technical test and interview questions for tata consulting engineering (TCE) i need it asap thanks in advance
What is offset in a control system.
In turbine what does term CDP, NH, HSSOC means.
draw shematic diagram of c/v positioner(smart type)?
