Interested to Buy Any Domain ? << Click Here >> for more details...
During the design and engineering of a process plant, a good
designer should plan for ____________, ___________ and
____________ aspects of the plant
- 1 Answers
- 3718 Views
- I also Faced
- E-Mail Answers
Answer Posted / john
During the design and engineering of a process plant, a
good
designer should plan for _the process requirements_,
_client specifications_ and
_fundamental_ aspects of the plant
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
it is possible to check the fail safe condition in pressure transmitter. if possible how?
what is span value and zero ? and how set ?
why fuse block is not used for AI signal?
Working principle of magnetic flow meter ......and calibration procedure of e+h magnetic flowmeter...
how to check earthing,what is minum ohms for proper earthing
When doing a liquid seal on a differential flow transmitter , most of the time the sealing liquid will be heavier then the process fluid. For wich application will the sealing liquid be lighter than the process fluid if transmitter is mounted below the process line.
Hi i m B.E. In elect. & comm. I m workin in bio mass plant from 6 mnths as inst. Engg. but now i m in dept. Of operation as shift engg...which is best operation or inst. 4 me? M confusd..plz help and reply me..
What is the calibration procedure of Drum level transmitter if range is 0 to -400 mmh2o in lab?
Can I route 110 VDC and 24 VDC in a same Duct for our Interposing relay cabinet? IF yes or NO Please provide me IEEE Std. for the same. Please i required it on Urgent basis, i need to design IRP Cabinets and we have MCC 110VDC and Our Coil side is 24VDC, Please help as soon as possible.
A DP transmitter is used to measure the level of an open tank. The drain line of the tank is connected to a control valve, and is configured as, if the level of the tank is 90% the valve should get open 10%. And if the tank level is 10%, the valve should get open 90%. Draw wiring diagram and explain how to configure DP transmitter and control valve using HART communicator. If the span error at output is 1%, what will be the %opening of the control valve at 60% level of the tank?
Explain the working of an electronic level troll.
How to Calibrate Ultrasonic Level Transmitter in field
in sulfur process what is material of impulse line we use to connect with transmitter ? and does teflon affected by sulfur?
What are the different types of thermistors used in industries? How to the operation of typical thermistor?
give eg of how I/P is used in control loops
