Interested to Buy Any Domain ? << Click Here >> for more details...
for any load, what happen if we use the cable rating above its
normal rating
- 2 Answers
- 5006 Views
- I also Faced
- E-Mail Answers
Answer Posted / reddy
No problem with higher
rating. Its safe. Only
cost increases
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
how to calculate kvar in Akiva
Batteries. What is the difference between Lead and Nickel batteries ?
State and define ohm’s law?
what & how to check the lightning arrester
Explain Need of a starter in a dc motor.? Also explain any two starting and speed control method of dc motor?
What is meant by RVT and NDR ? expansion and details of it
How generator NPS(NEGATIVE PHASE SEQUENCE TEST)TEST WAS DONE? PROCEDURE WITH DETAILS?
Explain different types of d.c motors? Give their applications
What is Instantaneous Earth fault relay,how will work
why we have to particulary use ACB for below ratings,even available of MCB,MCCB with that range ?
Do you need any help with FEWA Electrical Supervisor exams?
I need to connect a synchronous generator to the grid using automatic synchronization and two circuit breakers (one for synchronization, one for end connection to the grid), how to determinate the required diameter of the cables?
What current flows in the transformer primary when its secondary is open?
HELLO EVERYONE, I RECENTLY HAVE FOUND ONE PROBLEM, I WAS TAKING NO LOAD TRIAL OF AN HT MOTOR 920 MOTOR , 1440 RPM , 6.6 KV, WITH AUTO TRANSFORMER. AT 450 V, LOAD WAS 40 AMP AND SPEED WAS 250 RPM. BUT AS WE INCREASE VOLTAGE FROM 450 TO 480V, LOAD BECOME 41 AND SPEED REDUCED TO SOME RPM . SO WHICH PHENOMENON ACTED HERE FOR REDUCING SPEED.?? AND IS IT HAPPENING ALWAYS OR IT IS RARE? I ALSO HAVE FACED SUCH PROBLEM WITH FEW LT MOTOR ALSO.
What is the effect of pd controller on system performance?
