what should we do when the CT secodary gets open? how do we
short circuit it? using tester or screw driver? not
dangerous?
Answer Posted / velu5185
no sec open plz short it because sec open CT ill burn
Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
what is the effect of change in supply frequency on load angle of synchronous motor,all other parameters remaining same?
Difference between control junction box (cjb) and power junction box(pjb)?
Is the theorem applicable to ac sources?
in cvt,there are two windings,1a,1n and 2a,2n.in my one project i use only one winding i.e.1a,1n. the other winding is not in use, so i connect it in open delta and want to close it by ibsertibg thermal resistor. the output of cvt is 132kv/115/sqrt3. plesae tell me exact value of resistor, so i may close it to avoid the resonance phenomenin. send me answer on this email adress please. aetcon-po@aetcon.com
why do we not use equivalent voltage source in negative sequence equivalent ckt.
In diesel generator how AVR get voltage to excitation. And basic diagram DG EXCITATION CIRCUIT.
On what basis do you decide the ONAN (Oil Natural air natural) or Dry type transformer for a project?
why do we carry out winding resistance test?
how to interlock 3 nos MCCBs using under voltage coil. please provide me circuit diagram?
AL=0B9H,bl=75H, ADD AL,BL AL=____________? CF________? OF___________?
where was current transformer protection units used and why??
how will we calculate the copper wire load..
what is the saturation point of crgo lamination.
What is Bolted fault?
How to calibrate or test an LT Air Circuit breaker 440 volts, 35 KA, 800 Amps ?