Interested to Buy Any Domain ? << Click Here >> for more details...
is manifold required for an integral orifice meter?
- 2 Answers
- 5045 Views
- I also Faced
- E-Mail Answers
Answer Posted / kanji
no it is not necessary to use manifold for integral
orifice. u can directly mount the transmitter on the
orifice assembly. use of the manifold is to work online on
transmitter.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Give Detail information about plc,dcs,and scada system?
can anyone can let me know in Eurotron Micro cal 2+ calibrator in milli amps source mode we are not able to get 20 milli amps output it only produces 1.52 milli amps out, but display shows increase in milli amps , and err6 displays, let me know how to remove the err 6.
What is the purpose of the analyzer in petrochemical plant?
Why 4-20 amps is being used in instruments? Why cant we use any other range instead of 4-20 amps? Why only 4 amps is taken as lower limit and why 20 amps is taken as the higher limit?
how does we calibrate a square root flow transmitter ,give an example and explain it step by step like range calculation , calibration hook up series connection , zero check , and how to apply pressure , and if not geting proportional output then what should we do ?
How d.p. Transmitter can be applied to close tank?
How process line mpm calculation is done?
How does your previous experience relate to the job you are applying for ?
How digital input and digital output 's are working in dcs
Who to difference between analog in & analog out in dcs?
What is the basic difference between Modbus and CAN Open Protocols
what is temperature compensation?
I want to measure and control level in tank of size 10*5 filled with gasoline, so plz give me the solution with clear details. how to select transmitter and sensors.
In Safe Guarding test what means by "Failed to Danger" ?
(1) In turbine, what does term CDP, NI, NH, HSSOC, means. (2) What is the purpose of LO overhead tank in turbines.(3) An equipment is certified for EEX, IA, IIC,T6, what do you under stand by this.(4) what is SURGE, and how it is prevented, what is the purpose of bypass valve across AS valve.(5) Give 2 application of quartz crystal used for process parameter measurement.(6) what is meant by cold float of compressor shaft. (7) state four different types of flow measurement. For gas flow measurement mmscfd is the common unit. Expand the unit and specify significance of word S in the unit.(8) what is meant by Gap voltage, in vibration measurement. Normally how much Gap voltage is set and state the reason.(9) what will the new flow factor if D/P transmitter is Re-Ranged from 25” wc to 50” wc.(10) what is the usage of QDV & Volume booster.
