Answer Posted / samira patel (itps)
IF TWO DISSIMILAR METALS ARE JOINED TOGETHER SO AS TO FORM A
CLOSED CIRCUIT ,THERE WILL BE TWO JUNCTION FORMED WHERE THEY
MEET EACH OTHER.ONE OF THE JUNCTION IS CALLED HOT JUNCTION
OR REFERENCE JUNCTION AND ANOTHER JUNCTION IS CALLED COLD
JUNCTION OR MEASURING JUNCTION.IF HOT JUNCTION IS HEATED AN
EMF IS INDUCED AND FLOWS THROUGH THE WIRE ,THAT IS MEASURED
BY A GALVANOMETER OR MULTIMETER.THIS EFFECT IS CALLED
THERMOELECTRIC EFFECT AND THIS IS FIRST OBSERVED IN 1821 BY
SEEBACK SO IT IS ALSO CALLED AS SEEBACK EFFECT.
| Is This Answer Correct ? | 2 Yes | 5 No |
Post New Answer View All Answers
How process line mpm calculation is done?
what is Best Among SINK Or SOURCE Type Design In Digital Signal, Either Iput Or Output? WHY?Can any one..
What is 3 selection available when configure the burnout protection for controller
How u will setup SPI(2007) on Citrix Server (Thin Client Mode)? Plz Justify?
give eg of how I/P is used in control loops
What is the meaning of wet leg
How does your previous experience relate to the job you are applying for ?
what is the diffrence between pressure safety valve & pressure relief valve....pls
How flow can be measured with dp?
Which Signal hart communicator work? If there any signal change when hart connect while transmitter in line ?
what is the difference between magnetic flow meter and mass flowmeter
Working principle of magnetic flow meter ......and calibration procedure of e+h magnetic flowmeter...
Drum level tx with GP4 with zero elevation:7300mmh20 on HP and 8050mmh2o on LP as range but on commissioning the tx readiing is max,Why this reading?
What is surge and how is it prevented, what is the purpose of bypass valve across AS valve.
What is ultrasonic flowmeter?
