Interested to Buy Any Domain ? << Click Here >> for more details...
How to test the thyresitor or SCR by multmeter?
- 5 Answers
- 8912 Views
- ABB, I also Faced
- E-Mail Answers
Answer Posted / engineering.force
initially increase the voltage across the anode-cathode
terminals of the thyristor. and note the value of current.
the current will be zero when scr is not fired. after a
certain value of voltage it will start conducting, the
current through the scr will start to increase and, the
voltage across the scr will drop near to zero.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What are the material used for resistor?
how can i reduce sparking without stepdowning the voltage
What is meant by load angle of an alternator? Upon what factors does the load angle depend?
i want to know that what is the eligibility critaria for ongc exam?
power transmission pole used one support , that only for support or earthing
Is any AC drive(VFD) had a feature of DC injection braking? if available please mention the detail. i.e drive can supply braking torque when the motor in idle state.
What is shunt voltage and u v voltage witch one best
How can calculate the rating of a servo stabilizer for given a specific load
by using pump duty, how we will can calculate the motor duty(KW)? is there any standard or formula.
Hi all I had applied for the RRB test in the ELECRICAL category. I would be pleased if any of you can sent me previous year question papers. Please forward the question papers to varshashahi@yahoo.com Thanks and regards Varsha
wheather the size of windings in motor and generator are the same
How do we calculate over and under frequency tolerance from generator data?
Give some differences between open loop and closed loop control systems.
how we can come to know that motor winding resistance which showing by DMM is right or wrong???is there any chart or something that we will compare & check???
According to IEC60034-14, When the vibration monitoring system required for motor Bearing. above which KW, it is required? and for what type of bearing the vibration probe is provided.
