Interested to Buy Any Domain ? << Click Here >> for more details...
I have seen the Temperature element (T/C & RTD) installed
in process line on 45 degree position, Why? What it mean?
How many types of tapping position for temperature elements?
- 4 Answers
- 11789 Views
- I also Faced
- E-Mail Answers
Answer Posted / rathna
I suspected, it may be the High pressure line if we
installed 90Deg straight there is chance to damage the
Thermowell.
| Is This Answer Correct ? | 1 Yes | 3 No |
Post New Answer View All Answers
Draw a complete P&ID of a flow suction tank indicating all control & protection equipment. Indicate all its inlets and outlets. Explain the controls for this system
you must show the examples application and give at least 4 types of transducer/sensors that can minimize the failure during the manufacturing of the resistors.
how to calibrate corollaries (Mass flow meter)?
If we increase only P what will be controller action ?
What is zone,loop/fire alarm system?
How to measure the dust in chimney(spm)?
How can a d.p. Transmitter be calibrated?
Calibration procedure for electro magnetic flow meter
when the instrument tapping on pipe line is located below and transmitter is located above the tapping point for liquid service transmitter, what should we do, is there any additional drain valve is required??
What do you know about gail?
why any measurement made interms of pressure is more accurate ? to be more precise most of the flow velocity is made interms of pressure and it is accurate. what is the reason behind pressure measurement being accurate ?
What is hp & mp seperator .& what is its working principle ?
Why trim span ? How?
What is Predictive Maintenance
what is the input to be given in digital flow meter during the the calibration time?
