Interested to Buy Any Domain ? << Click Here >> for more details...
why nutral and earthing wire connect with each other in
main panel board.
- 2 Answers
- 4982 Views
- I also Faced
- E-Mail Answers
Answer Posted / zubair
it is to provide the constant output voltage,irrespective
of variations in the load.
| Is This Answer Correct ? | 0 Yes | 3 No |
Post New Answer View All Answers
For a 6.6kV Motor it is recommended to do megger test with 500 V d.c and not more than 5kV d.c but the Hi voltage withstand test should be performed by 12kV AC. Why the dc voltage test should be limited but AC voltage withstand test could be with such a high voltage?
ratings of lightning arrester
What is the drawback of static coefficients?
what is RFID? thire application;
What will be the size of copper cable (each for 3 phase and 1 neutral) from Service connection Kit-Kat to Panel Board (i.e. to main switch) for a 6 pole 3-phase AC induction motor of 200 H.P. capacity? Amp-255 A, Frequency:- 1450 rpm.
Why are short circuit ratings always 16kA,25kA,36kA and 50kA.Who has fixed these?
What is different between Difnit time and instatous over current relay
What is the limitation of kirchoffs law?
What is excitation in case of dc motor?
in cvt,there are two windings,1a,1n and 2a,2n.in my one project i use only one winding i.e.1a,1n. the other winding is not in use, so i connect it in open delta and want to close it by ibsertibg thermal resistor. the output of cvt is 132kv/115/sqrt3. plesae tell me exact value of resistor, so i may close it to avoid the resonance phenomenin. send me answer on this email adress please. aetcon-po@aetcon.com
Where is servomechanism used?
direction of tarbine& genrator
Is any AC drive(VFD) had a feature of DC injection braking? if available please mention the detail. i.e drive can supply braking torque when the motor in idle state.
what will happen if i connect 12 volt battery with 24 volt battery charger.
Difference between Lugs and Thimbles
