How much should be the specific gravity of a DG set battery
Electrolyte.
- 2 Answers
- 6600 Views
- I also Faced
- E-Mail Answers
Answer Posted / n.venkidusamy
1200 to 1230 as such normal battery electrolyte.
| Is This Answer Correct ? | 6 Yes | 2 No |
Post New Answer View All Answers
What is the maximum number of swithes that can be connected in series up to down stream point in an LV Distribution system?
Why does increasing the magnetic flux in the main field of a d.c motor cause the armature current to reduce??
we have two generators different capacity on 15 MW and other 6MW at 11 KV , 15 MW gen. bus short level current 40KA,and 6MW short level current 25KA,, length of cable 100MTR between 6 MW from 15MW gen. for bus coupling . kindly tell any one can we use both NGR OR one NGR from any GEN. BOTH NGR has diff. rating. Tariq pakistan
234 MVA Generator 3 phase Short circuit current Values required? Gen set Rating-234 MVA, Gen Voltage-18kv, PF;0.8, Xdv:23.5 %, Transformer Rating-18/380KV, 680MVA,Yndd1 two winding, Step up TR, ZT:35.50 %,X/R 4.33 Gen CB Position, CB open ,Disconnected open, Generator Running Voltage 18 Kv, Bi mistakes generator side earth switch Closed during that time short circuit current level in 3 Phase required, and how to test on site 234MVA Generator Short circuit current,
why we cannot protect 100% winding of an alternator by using differential protection?
what is is the potential diffrence between two phase ?
What is meant by Load Encroachment in OHL Feeder Protection?
How to use computer cpu ups use for home inverter circuit board
what is the purpose of bypass mode in energy lighting transformer?
when we gave dc supply to 220v dc motor its rpm is 1200. then we gave 180v. how many rpm of its motor. gave answer with calculation at my ID.... ravizak@ymail.com
what is the question paper model for section engineer in RRB
one split ac how can told of this ac which Tr tell me us
How many size of cable required for a 300m long and 30kw inductive lode
if a number of plc s are there then how many modbus to be used
what is Different between Bilinear and Unilenier?
