Answer Posted / mr.georgemathews
Yes TSI stands for Turbine Supervisory Instrumentation.
But its not such a easy thing to understand. Turbine is the
Soul of any Power Plant. The job of every Engineer in any
Thermal Plant is to give maximum protection to the Turbine.
For that this TSI concept is there.
In order to protect our turbine we use more then 100 sensors
all around the turbine body depending upon the size or the
capacity of the turbine. These Sensors include
Thermocouples, RTD , Pressure gauge , pressure transmitter ,
temperature gauge, bi metal thermometer , temperature switch
,pressure switch . But most important Thing that we do for
the protection for a Turbine is we erect Vibration Sensor ,
Speed Sensor , Differential Expandtion (DE) semsor, Casing
Expandtion Detector or sensor (LVDT).
All these instrument gets the field result and send it to
the TSI. The TSI evaluate all the input from all these
sensor and control the governing valve and other related
Mechanism for a safe working of turbine.
But before we install all these instrument it is most
important that all these instrument should be thoroughly
Calibrated and their record b store prior being installed on
the field.
Is This Answer Correct ? | 7 Yes | 0 No |
Post New Answer View All Answers
Calibration procedure for Electro magnetic Flow meter
I have 0.75mm sq multicore cable (IS type) , can use instead of same type but 1.5 sq mm cable ? Note : The distance is around about 150 meter.
which processor is used in dcs.
Senior engineer's please help me, what is Loop Checking and Loop test? and write difference also? soon urgent
how works encoder in plc
Name different parts of a pressure gauge. Explain the use of hair spring in the pressure gauge.
What is 3 selection available when configure the burnout protection for controller
What is furnace draft control?
What is the use of gauge?
How we can check the 2 wire proxy switch? & how it is connected to DI MODULE OF PLC?
What are different types of orifice plates? State their uses.
why we use impulse line of flow transmitter at 45 deg. angle both side of orifice plate.
i am from instrument branch i want paper patern of mahagenco . any pevious years paper regarding my branch send me please . please.....
how pressurize drum calibrated ?
How we calculate orifice plat size???