Interested to Buy Any Domain ? << Click Here >> for more details...
what is the difference between impulse and reaction turbines ?
- 40 Answers
- 115030 Views
- Alstom, ATMS, NTPC, I also Faced
- E-Mail Answers
Answer Posted / pushkal
In impulse turbine there is no pressure drop in moving
blades, i.e. they are having constant cross section. Only
stationary balde or nozzle is used for pressure drop, i.e.
velocity increase.
In reaction turbine there is a pressure drop in moving and
stationary both blades, i.e. both blades act as a nozzle
for next pcoming blade, i.e. pressure drop & velocity
increase.
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
What are the properties of fuel oil?
What is the difference between Muff Coupling and Screwed Coupling with Cotter pin used in pump line shafts.
What does green field project mean?
What is elasticity?
Can you use motor oil in a hydraulic system?
How will you measure the eccentricity of the turbine rotor during running
wt is MAG weld? wr it is specifically used and reason for it .
asked about the power transimmisions and types of power drives and about milling different process types and differnce between straddle milling and gang milling
what will be the angular speed of a model of turbine whose dia is half of the real one and operating in 1/4 th of the head of the real turbine rotating in Nrpm.
What is difference between Higher calorific value and lower calorific value?
why oil lift in screw chiller during change of climate.
Crankcase oil mist detector
What is ferrite material?
2. Dry saturated steam at 3.5 bar is expanded through a convergent nozzle to 2.2 bar. The exit area is 5 sq. cm. Calculate the exit velocity and mass flow rate, assuming isentropic expansion and super saturated flow. b) A cast iron cylinder head is fastened to a cylinder of 750mm bore with 12 stud bolts. The maximum pressure inside the cylinder is 3 Mpa. The stiffness of part is thrice the stiffness of the bolt. What should be the initial tightening load so that the point is leak proof at maximum pressure? Also choose a suitable bolt for the above application 2 The propeller shaft of a marine engine is to transmit 600 kW at 1200 rpm, without a significant bending. The efficiency of the propeller is 88% at 32 knots ( 1 knot = 1085 km/hr). If the slenderness ratio is less than 50 and the permissible shear stress should not exceed 65 Mpa. Determine the diameter of shaft. 3 A semi-elliptic leaf spring consists of two extra full-length leaves and six graduated length leaves, including the master leaf. Each leaf is 7.2 mm thick and 65 mm wide. The centre-to-centre distance between the two eyes is 1.3m. The leaves are pre-stressed in such a way that when the load is maximum, stress induced in all leaves are equal to 380 N/mm sq. Determine the maximum force that the spring can withstand
Why did you choose this Mechanical Engineering Carrier? What goals do you have in your carrier? How do you plan to achieve these goals?
