Interested to Buy Any Domain ? << Click Here >> for more details...
how many earthing required for ups, what should be the
earth voltages
- 9 Answers
- 26294 Views
- Juniper Networks, I also Faced
- E-Mail Answers
Answer Posted / prabhu
Three Earthings are required.
1. DC side Earthing to avoid the distortion in the line.
2. Equipment Earthing
3. Electronic Earthing for the cards which works in low
voltage.
Where the internal convertor will have the Trafo, that will
be connected for the common earthing.
Both should not common, if Electronic items will get affect
when Ground current flows more than a limit.
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
How it can worked plc based electrical system And which type of software using.
In the ACB breaker capacity is 2000Amp but this each phase taken 1250 But total beldibg load is 600amp or 700amp watt is the problem
ANY ONE TELL ME ABOUT generator synchronization panel panel to synchronise 3 gen of 250kva both automatic and manual. 2 gen output vol 415 3ph, 1 gen output vol 400 3ph SEND THE DETAILS DIAGRAM ON THIS EMAIL ADDRESS ayazleo@hotmail.com as soon as possilble best ragrds electrical engineer ayaz mahmood SAUDI TECH
what is the function of Moulded case circuit breaker, why it is called Moulded?
How 48-relay (incomplete sequence) functions?
where are the circulat the diesel in DG parts name with pictue
How to calculate Voltage regulation of 22 KV Over head Line.
What are diffrent type of road taxes?
what is electrical machines
what is the role of energy meter in distribution system ?
What happens if the negative to earth voltage is greater than positive to earth voltage in the battery of substation?
The knee point of a current transformer is normally unique and known.So why in the nameplate of a CT they put the minimum value like this Vk> 400v.
i have a 4 Mva transformer 34.5 kv / 480-277 v and i used 2 parallel 3200 amp bus duct for the secondary feeder using 3 ply of bus bar ( 3/8" x 5" ) as a common where the flexible link terminated and 6300 amps breaker for the main, the lower bus duct reaches 70 degrees and the upper bus duct reaches 55 degrees when i used thermal scanner. why the temperature is not balance when the load reaches 3600 amps.
why high speed tripping relay will be used in tripping circuit why not normal relay
Explain The Application Of Storage Batteries?
