I am new in work for 1 of our project we have some instrument
in BOM including Pressure, Temp. and so on, I also noticed
some objects like pressure switch process HOOK UP; which I
don't know what does "HOOK UP" mean here.
- 3 Answers
- 4697 Views
- I also Faced
- E-Mail Answers
Answer Posted / george mathews
The Hook up Drawing is there to help the engineer to install
the transmitter. By following the Hook Up drawing we can
decide how a certain Transmitter with certain range can be
install at certain pressure and certain position ( tapping
is in horizontal or vertical). It tell us what are the
different product(impulse pipe size , manifold type , no of
gate valve to be used and where to b used ) to be use to
erect a transmitter.
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
how pressure transmitter work, what is its principal to measure and how its generate signal. for pressure transmitterinstallation which precautions must be taken ??
how can i calibrate the temperatuture gauge used by temperature bath(dry block) i mean step by step procedure?
What are primary elements of measuring pressure? Which type of pressure can be measured by these elements?
What is the start up procedure of desalter
what deference between panel earth and systemearth
What is Erosion in a control valve?
Which is your favourite subject & explain any one topic of it.
Can anybody please let me know Orifice plate sizing calculation formula and step by step procedure
Good evening all I need a small favour regarding reliance paper i wanna probable sample papers(e&i) of reliance. if any of u have any idea about dis then plz mail me back.i belongs to electronics and instrumentation engg.so i need e&i papers. thanking u....
What is Predictive Maintenance
Q-Explain the different load conditions that will produced different offset which may or may not be acceptable to thhe control function
Can any body tell me about SAP MAINTINANCE MODULE. WHAT IS its function and application. And study material Source about it. I shall be very thankful.
There are two chlorination tonners both are connected to two pressure swithes and the pressure switch is connected to SOV which operates the valve to changeover the tonner selection i.e if pressure one tonner goes low the other tonner should come in line if it is inautomatic selection design a circuit using relays ?
how to calculate the total flow in square root
while i check zero check for dp flow transmitter some fluctuating came (0 to 458 kg/h) what is the reason?
