Interested to Buy Any Domain ? << Click Here >> for more details...
What is the formula for Tapdensity /
- 6 Answers
- 17774 Views
- Dr Reddys, GR Intrachem, I also Faced
- E-Mail Answers
Answer Posted / bhupalreddy
Weight of the substance
Tapped density = --------------------------
Volume of the substance (after tapping)
The density of solids normally expressed in g per cm3
and liquids is normally expressed in g per ml. However
because powder volumes are measured in cylinders graduated
in ml, tapped density is expressed in g/ml.
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
why we use a particular hplc column for a particular compound give reasons?please
in gas chromatography what is the difference between gas flow rate and average linear velocity ?
Why sometime potassium ortho phosphate mix with acetone use for sample preparation for hplc
Why sodium hydroxide used for maintain pH of phosphate buffer
USP methodology, EP methodology, IP methodology, among three if possible to use one methodology for qualify working standard to use USP, EP, IP ? Please explain...
what is the importance of peak purity in HPLC and how we can calculate through manul(not software)?
What is the formula for relative diffrence for standard solution in solution stability in validation?
Ratio of Water and Acetonitrile(diluent) is not recommended to use in cleaning method validation,why?
I have compare C2H2-air and C2H2-N2O flame AAS on determination calcium. Both use same range of std to plot calibration curve. (2-6ppm) When i measure the sample with phosphate, KCl and LaCl, C2H2-N2O flame give false positive result, around 0.5ppm. When i measure the sample with phosphste, KCl and EDTA. C2H2-N2O flame also give 0.5ppm false positive. But both above mentioned sample would not give false positive when measured by C2H2-air flame. What is the reason?
Which are the diffrent grades of api in pharma?
what is the difference between potentiometric titration and karl fischer titration?
why should we perform dissolution PVT calibration only by UV spectrometer, not by HPLC ?
if identification threshold crosses the limits then what next step?
How to know the estimated LOQ concentration in ppm
from where i get mortar pastle for glass bottle crush? it's required for testing of it?
