Interested to Buy Any Domain ? << Click Here >> for more details...
there are two candidates p and q in an election.During the
campaign,40% of the voters promised to vote for P ,and rest
for Q.however, on the day of election 15% of the voter went
back on their promise to vote for P and instead voted for Q.
25% of the voters went back on their promise to vote for Q
and instead voted for P.suppose,P lost by two votes,then
what was the total no. of voters.
- 4 Answers
- 19860 Views
- GATE, I also Faced
- E-Mail Answers
Answer Posted / abhinand
110
| Is This Answer Correct ? | 2 Yes | 9 No |
Post New Answer View All Answers
Why use ball valves on Gas pipelines instead of gate & or globe valves...means basic diffrence or use of these valves..how designers knows this type of valve with rating is required...
SOME OF YOUR QUESTIONS ARE NOT MAKING ANY SENSE SO TRY AND PUT IN A LITTLE BIT MORE EFFORT BEFORE YOU POST A QUESTION. WE WILL ONLY HELP THOSE WHO WE CAN SEE ARE TRYING TO HELP THEMSELVES.
what is the difference between -24 : +24 & 0:24 and where it use?
Why do we have earthing cable in branch cable and shield in the same cable?
How to calibrate displacer type level transmitter (chemtrol make )for level measurement in hotwell , LP & HP heater ?
There are two chlorination tonners both are connected to two pressure swithes and the pressure switch is connected to SOV which operates the valve to changeover the tonner selection i.e if pressure one tonner goes low the other tonner should come in line if it is inautomatic selection design a circuit using relays ?
any questions on motor and energy conversions machines?
what is different between 2,3&4 wire rtd and how much maximum distance using plc to field.
which processor is used in dcs.
Why boiler chimney area oxyden sensor fixing?
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
How to erection of DCS Panel at site step by step
How INtools is useful for routine Instrument maintenance?
I am teja. I am studying Msc(tech) Electronics and Instrumentation (3years course) in Andhra university. But my course is not recognised by UGC and AICTE. Please tell me the job opportunities after this course. And i fineshed PLC course in IGIAT ,Vizag.Also complted my short term coure in SCADA, Seimans WinCC in ATI,Hyd.After Msc can i join Mtech for good job? or phd. How i can get good job in INdustrial Automation Side. Please give replay.Because this is my life matter.
Calibration of controller (pneumatic)
