Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / kyle condran
"Hello Guys,
If you only want to measure only and not control then, why
go for RTD or Thermocouple.
Just use a thermometer.
Think Simple."
RTDs and Thermocouples measure not control
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
What is the use of GMV in turbine?
What is the cascade control
What are different types of orifice plates? State their uses.
How to Calibrate Flow Switch in field
i want to find out iffco get test paper
Which tank weighing system is better to install (Accuracy point of view) 1) Tank weighing system with 3 load cell or 2) Tank weighing system with 4 Load cell
how to calculate control valve bonnet size?? or how to select its material?
What is instrumentation instrumentation engineering?
i have steam drum height 1000mm. and i want to placed the transmitter below the tap.how i calculate.
how to check earthing,what is minum ohms for proper earthing
Explain PID controller tuning & any one method used for it.
How would you choose differential range?
1. what is modbus cable? 2. what kind of communication we are using for the interface of DCS, ESD and Third party cabinets? 3. What is serial communication and peer to peer communication?
How is flow measured in square root?
I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?
