Interested to Buy Any Domain ? << Click Here >> for more details...
Can you explain operating principle of Inverse Definite
Minimum Time” (IDMT) relay
- 2 Answers
- 13528 Views
- I also Faced
- E-Mail Answers
Answer Posted / naresh
it is the combination of inverse & definite time
characterstics.......
in inv time cahr relay the time of operation is inversely
proportional to fault current i.e, more fault current less
operation time......
in definite time irrespective of fault current the time is
constant....
in the above question the time will be varying inversely to
some extent and after saturation of the relay coil it is
having the properties of definite time relay....
| Is This Answer Correct ? | 8 Yes | 1 No |
Post New Answer View All Answers
Benifits of 3ph 4 wire metering over 3ph 3 wire
Explain dc generator with its types?
11000volt DG set carnt kaise banvay
Disadventage of cable-gland earthing if any ?
When a single pase capacitor run motor- run on 230vac and Case(1)run with 8 Mfd 250 vac.capacitor , Case( 2) run with 8 Mfd 400vac capacitor. What is difference between both case regarding power ,efficiency etc?
Why back emf used for a dc motor? Highlight its significance.
what is load vs Torque curve & why it is used?
what is servo motor and how it works?
Z transform is use when system is not a) converges b) diverges
We have 90mX100m hangar with 16 no.of supporting pillar. It is required to provide power supply on all pillars. what is suggested earthing scheme for hangars.
Factory acceptance test. FAT. For 132 kv transmisstion towers what is that meaning and what are the tests commonly companies perform now days.
We are preparing another project which involves Waste heat recovery from a 1 MW GE Engine. The Engine in particular gives out flue gas at 487Deg C with a flow rate of 5650 kg/hour and this can be cooled to 180 Deg C. This gives a thermal output of ~ 594 KW that is available for input to VAM via heat exchanger / boiler. Additionally 581 KW will be available from engine jacket water (temperature profile 80/ 80 Deg C and a flow rate of 50m3/hr) Our estimation is that 300 TR of cooling is possible with a suitable VAM machine(s). Please advise what is the most suitable arrangement with maximum TR and min Capital expenditure. plz reply me as early as possible
How Can you do Maintenance of ACB of 2000Amperes
What is the meaning of utility ground and clean ground? How the distribution panel is grounded?
While testing a ZCT what parameters have to check or measure?
