what the effect will occur if we increase the airgap in
induction motor
- 4 Answers
- 11114 Views
- IES, Tanfac, I also Faced
- E-Mail Answers
Answer Posted / raja
Power Factor gets decreased
| Is This Answer Correct ? | 8 Yes | 2 No |
Post New Answer View All Answers
what is the purpose of high speed earth switch in gas insulated substat
The transmission does not have options: a)Partition noise b) Flicker noise c) resistance d) Short noise and reason
2- What are the percentages between excitation currents in phase (R, S and T) in ∆ and Ỵ connections in excitation Current test in transformers?
how mass curve differs from hydrograph.
what is the interrelation between voltage current torgue speed and magnetic flux in case of different types of electric motors
WHERE NEUTRAL WIRE IS CONNECTED AT DOMESTIC TO TRANSMISSION LINE(SINGLE PHASE TO THREE PHASE)
primery try cell?
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING)IO (current operating
Write masons gain formula.
in battery charging room we find two fuses (one in positive other in negative cables ).why it is so?one fuse is ore than sufficient?
does a DG set has low fault level as compared to that of a transformer.If yes then why.
In the Variable Voltage Variable Frequency Drive, how the Voltage and Frequency varied ? Is it varied in the Inverter part of the Drive ? Please give us supporting document if any.
THERMAL CAPACITANCE IS MEASURED IN..................................................
what is the correct format to create a resume for interview??
we have earthmat at 110KV substation.we would like to take earth resistance.b some says that by connecting earth megger terminals (C1,P1) at middile point of earthmat (at riser) will cause voltage gradient at other earthmat nods and dont get exat earth resistance.when connecting at end nods will get exat value . is it correct .please explain
