Interested to Buy Any Domain ? << Click Here >> for more details...
where AVR is connected in power plant.
- 7 Answers
- 13118 Views
- ABB, Saudi Red Bricks, I also Faced
- E-Mail Answers
Answer Posted / g.sridhar
used in RTCC PANEL and alternator excitation
| Is This Answer Correct ? | 2 Yes | 2 No |
Post New Answer View All Answers
which VFD is better ( LT or HT)
how we decide scurt (disc) of insulator with respect to kv rating
how does a shunt reactor maintains the bus voltage???
we can run 2phase as 3phase .what will be the differnce with respect to phase angle, power, current between the two modes
Whether power factor should be high or low? Why?
What is reactance, reluctance,capistance, pls give answeer in hinglish and be simply Jo asani we smajh m aa jaye
1)we have 1000 cfm Blower,Dia-1Mtr,Velocity of air 94 m/s 2)We have Natural Air velocity 94m/s 3If i Put Wind Mill in natural air ,speed is 94m/s Then it will generate Assume 100kw 4)If i put same wind mill across the Blower,air speed is same 94m/s now the Question is Will it generate 100 kw?
i want to run 11kv star connected motor in 6.6kv with delta connected throught inverter, is it possible?
Why phase sequence must be same in any ht motor or generator circuit?if phase sequence doesn't same whatever will be affect on circuit?
what are the advantage and dis-advantage of 3 phase 4 wire energy meter?
how solar power plant energy meter multiplication factor
What is FM200 Gas??Applications........
can anyone provide me a amf panel control wiring using ec-2 relay?
We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?
During FEED, you will have all the information with regards to cable. How will you calculate the MTO for MV and LV Cables? what are your considerations?
