Answer Posted / naresh kumar

Reasons:
1)to reduce the conductor size of the feeder.... i.e, by
increasing the voltage levels the current level decreases to
maintain constant power.. the feeder design depends on the
current levels so lesser currents lesser will be the cross
section...
2)by increasing the voltage levels the current levels
decreases so the i^2 R losses decreases and the transmission
efficiency increases.

how we calculate electrical load on a building according to area?

2848

---

Why is water motor not taking the pressure? what is the problem?

1626

---

why we need to us lenz's law for synchornous motor

2624

---

what will happen if ac and dc supplies given

2187

---

What is Anemometer used to measure?

1179

---

HOW TO CALCULATE CAPACITOR BANK OR HARMONIC FILTER CALCULATION

2386

---

Why back emf used for a dc motor? Highlight its significance.

1245

---

How to prepare electrical preventive maintenance plan & shedule of machine tools in manufacturing unit.

2230

---

why do you add the load short circuit impedance when considering short circuit amperage. It seems that you should only consider supply. If you need to consider loads and you don't know what loads are to be added , what would be a good sub-transient reactance rating for the loads?

1836

---

i want to run 11kv star connected motor in 6.6kv with delta connected throught inverter, is it possible?

2085

---

how to calculate the formula of cable size if motor kw is given

2352

---

I need the list of Universities who have summer intake for BS degree in Electrical Engineering.?

2142

---

in ring main system we use the isolater b/w transfer bus and main bus if we r not use isolatar than wat will be the effect in our sys.

2146

---

How the circuit breaker is selected for Induction motor of 100 kW, 415 volt, 0.85 power factor, 0.95 efficiency ?

1660

---

Why do we require transformer with less specific weight if supply frequency is increased?

1627

---