What is the difference between sensitive earth fault and
restricted earth fault in power transformers?
Answer Posted / surendar
Restricted earth fault function only protect the specified
zone .But sensitive earth fault function can protect all
earth faults(only applicaple for after start of ct point).
both protection analog inputs taking from neutral ct of
power transformer.but in ref taking ct reference for all
phases of ct for making protection of specified area .
setting of ref lesser then sef.sef also back up for ref.
both protection only applicable for star side for
transformer
Is This Answer Correct ? | 11 Yes | 6 No |
Post New Answer View All Answers
I meggared my 2c*70 sq mm AL AR XLPE cable. its one end show 50 M ohm . is my cable is safe for laying. I have only one phase and neutral.
Is single load(eg: three phase motor) having all the components like positive,negative,zero sequence components during fault condition?
how to calculate the lightning arrester conductor @ no of earth pits required
Atwhat condition reverse power relay will act?
how to find the voltage's of a transmission line plzz help with pictures i am not able to understand
can you send me the placement papers of electrical engg. from companis like NTPC,DRDO,IOCL,HPCL,BPCL etc.?If,plz send as soon as possible.Thanks.
What are dcs and plc?
Did RMU have ct and pt ?
What is a difference between indoor transformer and outdoor transformer of same rating
how to set the time in digital timer ?
what precautions to be taken while desigining a LT,HT panel. Eg-LT panel PCC panel with ACB installed. HT panel VCB panel with VCB installed. & what is main diffrence betwn IP54 & IP55 construction of panel.
Is there any guideline say about display of earthing value near to earth pit
what is difference between window type and wound type transformers?where we will use window type and wound type transformers?
what are the different methods for the starting of a synchronous motor.
fuel-air ratio in a petrol engine fitted with suction carburettor,operating with dirty air filter as compared to clean filter will be