in which mode of the zener diode act when load voltage is
approximately constant
- 1 Answers
- 3268 Views
- I also Faced
- E-Mail Answers
Answer Posted / santoshkosuru
the load voltage is approximately constant when a zener diode
is operating in the breakdown region.
| Is This Answer Correct ? | 11 Yes | 0 No |
Post New Answer View All Answers
how to calibrate Necleuonic level transmitter.?
how to turbine speed measurement?
how is work pressure switch& level switch?what is the principle of this?
How do you identify an orifice in the pipeline?
what is Best Among SINK Or SOURCE Type Design In Digital Signal, Either Iput Or Output? WHY?Can any one..
what are the selections available in configuring a burnout protection of a controller? thanks
how can leve transmetter calibate in feild .and also put cv and flow plz .....
Operational amplifiers
what is zero and span ?
why we are using magnet for calibration of gas detector?
DEAR SIR/MADAM MY NAME IS ARKAPROVA BHATTACHARYYA.I AM A FRESHER INSTRUMENTATION ENGINEER.CAN YOU PLEASE SEND SOME QUESTION PAPERS OF GRADUATE ENGINEER TRAINEE EXAM OF DVC(DAMODAR VALLY CORPORATION).MY EMAIL IDs ARE arka_aec@rediffmail.com.
What is megering????
why we are not using the turbine flow meter in the steam service?
Dear Friends, we are planning to design Power distribution and Fiber optic in the same cabinet.Like Front side Fiber optic and Rear side Power distribution.Is it any possibility of problem occurs like interference etc? Your answer is highly appreciate.
How hart protocol can be connected with control valves?
