can we use 3 phase UPS for Motors and Other Machines
- 4 Answers
- 9185 Views
- ACC, I also Faced
- E-Mail Answers
Answer Posted / vaseekaran
We can use the UPS for the motors.but we have to select the correct rating of the load.while selecting we have to keep the time we required to load to run through ups.
| Is This Answer Correct ? | 1 Yes | 2 No |
Post New Answer View All Answers
Should power factor be low or high?
Why HT 11 KV Slipring Motors are connected in star ?
what is Anti-pumping?
Why is voltage is required to be within permissible range for an electrical equipment?
How can we increase the capacity of Energy.?
What size cable (based on voltage drop) is required to supply a 40 A three phase boiler if the wiring system is 75V single insulated cables installed in non-metallic rigid conduit 56m from the main switchboard? Voltage drop in the consumer's mains is 8V.
why would amp draw on neutral wire be as much as amp draw on the hot leg.
What do you mean by Frame 5 Gas Turbine as well as Mark II.
i m electrical diploma holder i want to do plc $ Scada some body tell me which insitute is best for me near chandigarh
what are factors to be consider to design a HT & LT motor?
WHERE NEUTRAL WIRE IS CONNECTED AT DOMESTIC TO TRANSMISSION LINE(SINGLE PHASE TO THREE PHASE)
how can we say that stator magnetic field rotates with synchronous speed?can we derive?
What are the site acceptance tests for power cables, DG Sets, LT panels & 30kVA UPS ?
State Maximum Power Transfer theorem.
How can we calculate the motor frame sizes?
