Interested to Buy Any Domain ? << Click Here >> for more details...
why we are called the 4-20ma transducer,not 0-20 ma
transducer??
- 3 Answers
- 5654 Views
- I also Faced
- E-Mail Answers
Answer Posted / vaseekaran
Let us keep the value as 0 to 20 mA,
The valve we measure in the output will be zero if the meter is in idle state and also it will show the same zero even the instrument is in fail condition.so we cannot get the exact and get confused if there is a problem in instrument while cross checking.this is the reason we are using 4 to 20mA.if the instrument fail then we can get only zero and if the instrument is idle we will get 4mA.so we can easily differentiate it.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
we are going to install a solar PV site and how can we calculate PV Solar Panel Efficiency, can anybody tell me complete method for its calculation.
How To Convert Apparent Into Real Power Without Knowing Reactive Power?
WHY THE COLOR OF OUTDOOR TRANSFORMER IS BLUE ONLY???
Why the efficiency of a three-phase induction is the motor is less than that of a three-phase transformer?
Explain what cmos is and its benefits?
When we connect the large capacitor bank in series ?
Differnce between negative Pahse SequenceFunction and unbalance Function?
Why different Pressure switch used in marine boiler water circulation system
How LT megger works ?
Following test should be conducted to find out relative polarity of transformenr terminals A no load test B back to back test C phasing out test D none of above
What are factors to be considered while we selecting the Core Balance Current Transformer for Earth fault protection
How much kv gas generator is needed to run 2 hp and 1 hp airconditioners, plus a refrigerator and 4 Tvs
how to calculate earth fault relay current and CBCT ratio
What is resistance reading of earth copper rod with grid and without grid?
What is making & breaking current ???
