Answer Posted / rajesh
a relay is just a small part and is usually a part of plc
plc is a system which has number of i/o controls
plc is much large compared to a relay
| Is This Answer Correct ? | 1 Yes | 3 No |
Post New Answer View All Answers
What is the minimum value of hfe for the oscillations in transistorized rc phase shift oscillator?
L.A. (Lightening Arrester) is located at a place from where transmission line enters the transmitting substation. So L.A. (Lightening Arrester) is the first equipments which has to encounter with lightening, high voltage surges and switching surges. It has to absorb energy of lightening, high voltage surges, and switching surges. L.A. (Lightening Arrester) is made up of layers of semiconductors. If these layers can not tolerate energy released by lightening, high voltage surges, and switching surges the L.A. (Lightening Arrester) blasts.
why you don not show protection and type of isolation in key single line diagram?
I have doubt that the supply HZ (very low or high than rated ) may affect the power factor. is it true. ?
What is meant by short-pitched winding?
What is quadrantal symmetry?
block diagram of 2 ups system connected in hot stand by mode?
What size cable (based on voltage drop) is required to supply a 40 A three phase boiler if the wiring system is 75V single insulated cables installed in non-metallic rigid conduit 56m from the main switchboard? Voltage drop in the consumer's mains is 8V.
I need the list of Universities who have summer intake for BS degree in Electrical Engineering.?
What is mean by hot and cold loop testing? What is the difference between them?
what are safety measures in /control in diesal engine/ explain them?
What happens if the series current double?
High speed earth switch operation with diagram
How to calculate that clean water supply in one Day from 150 KLD STP?
is there any device that works properly accept relay, it may be fuse but if i want fuse of 33kv 300 amp it is avaliable, pls give me details