how does the belt tension is checked and what should be the tension?
Answer Posted / sandy
The bolt tension is equal to how much we tightened the nut.
the tension is depends on force exerted by nut
Is This Answer Correct ? | 0 Yes | 5 No |
Post New Answer View All Answers
How to report calorific values of fuel?
What is the function of AUTO SHUT OF Valve in Diesel Engine?
Between steel, copper and brass, which conduct faster heat.
why there was 17 stage of compressor in the most of the gas turbine . depending on what?
HOW TO CALCULTE THE TR CAPACITY FOR SCREW COMPRESSOR, RECIPROCATING COMPRESSOR,PHE & COOLING TOWER? HOW TO CALCULATE THE FLOW RATING OF PUMPS?
how to minibar working
Steering handle (round dial) of motor vehicles (CAR,BUS,LORRY) wiil be designing with two cross supports without 180 degree straightness( it will be little bit cross). Why?
My vendor filled liquid oxygen in our 11000 liter capacity tank. He filled from 1400 MMWC up to 3200 MMWC. I followed the provided conversion table and found that we had been supplied 1800 MMWC liquid which is going to yield 2815 cubic meter. On the other hand, the vendor claims that he supplied as follows:- 5236 cub mtr(3200 MMWC)-2124 cub mtr(1400MMWC) = 3112 cub mtr. I fear that he wants to charge 297 cubic meters extra. He claims that my method was wrong and his was right. He says that this disparity is because of the conical shape of the base of the flask. I will be thankful if somebody can explain me the truth.
Action plan to closr NCR (NON COONFORMANCE REPORTS)
What is a torque converter?
Which impurities form hard scale and which impurities soft scale ?
hi this is ravi , i was short listed in hal assistant engineer, now im going for interview can anybody help how is the interview for mechanical stream very urgent if anybody knows forward to me my mail id i.ravibabu2@gmail.com
If saturated temp of water is 99.8degc at atmospheric pressure,then how the water of sea is evaporated at normal temp
Hiii...I am from instrumentation dept in last plant and now in new plant management transferrd me to turbine dcs operation...how and which way I can prepare for dcs operation...time is just 1 month...???
As compression ratio increases, thermal n increases. How is thermal n affected by weak and rich mixture strength ?