Interested to Buy Any Domain ? << Click Here >> for more details...
What are the effects to a distribution transformer rated
10Kv with ratio 10Kv/0.433Kv, 3phase 50hz for example but
fed with power supply of 11Kv?
- 2 Answers
- 4239 Views
- I also Faced
- E-Mail Answers
Answer Posted / vipul parmar
our power generation on 11kv so.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
33kv substation lay out details & line to line & line to earth measurements
give some advantages and disadvantages of combiniing the session, presentation, and application layer in the osi model into one single application layer in the internet model
What is a dominant pole?
Can any one know what are the symbols at the down (below) the analog ammeter??? there are 4 symbols which are they ?????
The electrical energy required to raise the tempreture of a given amount water is 200 kwh. If the heat losses are 20%, the energy required is?
What are the main faults of DC generators?
define displacement & magnitude ?
why the neutral point in connnection oscillates?
why magnet has north and south poles only why not east and west and why we are considering as north and south poles? why cant we consider as east and west?
please send me previose rrb junior engineer qustion papers
1.what is the difference between transformer differential and busbar differential.2)why we are using 2 slope for trafo diif and 1 slope for busbar diff.3)what is the purpose of metrosil and stabilizing resistor in high impedance relay circuit.4)how metrosil reduce the peak volage.5)what is the funtion of stabilizing resistor
Give some differences between open loop and closed loop control systems.
What is the working mechanism of OLTC in Power Transformers????
1)what is the function of a frequency inverter? 2)If a few frequency inverter are connected onto a device network,what are the two setting that will ensure the frequency inverter work properly on the network. 3)whats is the name of the input sensor for weigher? 4)How to confirm that the load cellis faulty? 5)Describe briefly the steps to validate that the weigher is working properly? 6)Describe the procedure to validate the flowmeter accuracy? 7)Describe briefly the steps to validate that the tempreture sensor/transformer is working properly. 8)what is the adjustment that need to be done when you are calibrating the temperature transmitter ? 9)what are the safety measures to be taken before disconnecting motor for rewinding. 10)whats is the synchronous speed in rpm of typical 4pole 50hz motor? 11)whats is the formula for kw, ohm's law 12)if a 3phase motor is rated 3kw,415vac,what is it's rated ampere?
A 230V dc shunt wound motor has an armature resistance of 0,15Ω.When operating on no load at 650 rev/min the armature current is 6A . The motor takes a full load current of 85A. Calculate the full load speed if the field flux is (i) maintained constant (ii)reduced by 0,03
