Answer Posted / siva
The Goerges phenomenon is the operation of a 3-phase wound-
rotor induction motor at half of synchronous speedand it is
obtained by unbalancing the rotor circuit. If the motor is
started with one rotor phase opened or with rotor
impedances greatly unbalanced, it will accelerate to half
speed and operate stably as a motor or generator.The motor
may be operated stably at half or full speed. The torque at
half speed is greater than at full speed, and may be almost
as great as the rated torque for a balanced rotor. It may
be desirable to operate an induction motor at half speed
intermittently or as a temporary measure. Disadvantages of
half speed operation are the low power factor, low pull-out
torque, the subfrequency line currents, and motor
vibrations.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
what are the maximum available current, voltage ratings and switching speeds of the power electronic devices thyristor, power mosfet, igbt, and mct?
Do Phase angle measurement have any application in freq/harmonics measurement? If so how?
I have a small system with two motors that are running on 380 vac, 60 hz. These motors are expensive and I usally get them from Brazil. I am adding another motor to the system, but I want to purchase a 480 vac, 60 hz motor to use. It will be on a VFD that is rated fro 380 thru 480. Is this posible and will I have to use a larger motor and derate it?
CT Ratio of a energy meter connection is Red Phase : 100/5A, yello Phase : 50/5A & Blue phase : 100/5 A what is the overall Multiplication factor
Why line VTG = √3 phase VTG in star? How?
What is DTR erection?
What is lifting power for 1 wb/m2 and 1 A magnet?
How do we find the rating of a transformer, if it got burnt badly.
Define resonant peak?
What is diversity factor in electric installations?
If I have 3 essential main switch board and 3 incoming electricity ,but only 1 genset running is that possible.
what is the formula for calculating the phase clerance between two phases and phase to earth how to calculate the cable for a motor
dg earth connect only in the amf panel or not why
what is meant by impedance & transient protection?
can we find the inductance of a induction motor?
