Interested to Buy Any Domain ? << Click Here >> for more details...
sir,
my question is that if we start any three phase
induction motor with star connection.will be current taken ?
please send a formula.
- 4 Answers
- 10679 Views
- ABB, I also Faced
- E-Mail Answers
Answer Posted / subhash sharma
P= root 3 V I Cos fi. and I=P/root 3*V*Cos fi
is common formula rather motor is running in delta or
star.formula remains same.where:
P= Motor capacity in watt
V=Applied voltage across stator
I=current drawn in amp
Cos fi= power factor.
| Is This Answer Correct ? | 11 Yes | 1 No |
Post New Answer View All Answers
what is the difference between electrical choke and electronic choke?
define digital electronic
show the single line diagram of star delta starter with single phase preventer
1.Z transform always lies around ? a) origin b) pole c) zero d) z=1. Multiples Mcqs which is bother me can’t find answers on internet. Some help required with little explanation . Note: this is not homework or related to any test. Thanks
High voltage test procedure of in swgr board. why should measure millivolt drop on testing time?
I need to connect a synchronous generator to the grid using automatic synchronization and two circuit breakers (one for synchronization, one for end connection to the grid), how to determinate the required diameter of the cables?
what is meaning of 230volts ac 50hzs ac supply is it rms or maximum to getting ac 230v what amount of max voltage they will send
A d.c. Shunt motor is found suitable to drive fans because they require?
WHY DO VOLTAGE TRANSFORMERS FAIL DURING EARTH FAULT IN THE DELTA CONNECTED 6.6KV ELECTRICAL SYSTEM
what happens to the water pump if ground water level is slowly decreasing?our water pump is varying from no-load full-load due to this problem
What is mean by STUB protection?
what is earth-fault?when it occurs? to check where it occurs what type of test should we do?
What descriptive information does the NEC require to be marked on all conductors?
May I know how much values to be set for earth fault, over current and short circuit values at 11kv side? I have 11kv van 1250amps rating. Present it's taking load 80amps?
give some advantages and disadvantages of combiniing the session, presentation, and application layer in the osi model into one single application layer in the internet model
