Interested to Buy Any Domain ? << Click Here >> for more details...
in construction feild make the column rods are uneven ( e.g
1 column we have 6 nos of bars that 6 nos of bars are
varrious level- 1 bar 10';2 bars 9';3 bars 8') what is
resion to put different level if difference are required or
not?
- 3 Answers
- 6625 Views
- I also Faced
- E-Mail Answers
Answer Posted / dheeraj singh
yas diffrence lvl r requird , resion is this as per IS 456,
overlap of the column not to be place not more than 50% at
a section, so that we put the diffrent level of the column
bar to aboid the 100% over lap at any section of column.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
please what are the required bars for a beams of 6mx6m and 450x300mm, one is continuous and the the second is discontinuous ..Its a commercial building (church)
which red: used in roof teping, then use only cement
What Reinforcements Are Used In The Process Of Prestressing?
For what building Built-on balconies are preferable? What are the advantages?
WHAT R THE GENERAL TECH QUESTIONS ASKED FOR THE INTERVIEW FOR AN AUTOMOBILE INDUSTRY,SPECIALLY DESIGN DEPT
IS STEEL BARS IS AS PER ISI TRANSVERSE RIBS SHOULD BE UNIFORM IN DISTANCE, PLEASE EXPLAIN WHY,
How will you reduce the concrete flow after mixing the concrete
how much cement and sand consuptin in 4 inch siporex walls 100 sq ft
what is a well
how to calculate testing date
As per Kandal suggestions, we have implemented rolling starts on 140 (+/- 5) degrees and we kept 3 rollars to complete the rolling before falling 125 degrees and the Aggregate AIV is below 22. But When the DBM bed is being rolled 3rd high viabration, (Before 1 plain & low ,2 high Viabrations), the aggregate is getting sharp edge agg. projections are damaged. As the literature is said that, the VG-30 Grade having better control the temp. susceptibility than Penetration grade. if so we could not get this problem at site. But we are facing on site. let me know.
how beam.coloum ,slab, footing are designed as per indian code.. detail procedure?
length where bent up is made in slab of bridge from one end
give me the rate analysis for Bituminous Macadam and SDBC
3. A vane 12.5 cm long, 8.8 cm dia was pressed into a soft clay at the bottom of borehole. Torque was applied and the value at failure was 55 N-m. find the shear strength of the clay on a horizontal plane.
